Community Feedback

 In Community

The Engineering Resources team is trying to solicit feedback from the community. Our goal is to make it as easy as possible for you to get your job done. With that in mind, we’d like to check in with you and get your thoughts on what hasn’t worked well for you.

This is intended to be an open-ended question. However, here are some specifics to help get you going:

  1. What were the biggest obstacles you faced when you started?
  2. What are the biggest obstacles you face now?
  3. How do go about getting help? What format do you prefer it in (websites, videos, etc).

Feel free to comment here, or send me an email (

Recent Posts
Showing 2 comments
  • Alison Chaiken

    From the MeeGo 1.2 release onward, we require hardfp-enabled hardware-accelerated graphics. I pre-ordered a Snowball but returned the board when the first BSP had no direct-rendering support at all.

  • Victor

    What would be nice are tiny examples of how to use the various hardware. I would like to see code showing how to
    a) set up one GPIO pin for input and one for output and have them communicate via interrupts
    b) set up an SPI port and use DMA transfers
    c) configure and use a touch screen
    d) setup and use a serial port
    e) setup and use the DSP